The SpinPro trimmer is one of the most helpful and innovative inventions since sliced bread! The high-quality gearing of a SpinPro is what sets it apart from its cheap imitators. The trimmer greatly reduces the time it takes to remove unwanted materials from your crop (Ten times faster), this allows you to get on with more important jobs. The SpinPro Trimmer is made from a high-quality medical-grade stainless steel casing making it virtually indestructible. It also contains rubber fingers that help turn the crop within the trimmer which is also a high-quality food-grade rubber. The SpinPro Trimmer has no mechanical working parts so its simple to use and can be used by almost anyone! All you have to do is turn the handle and the SpinPro does the rest!
When your Trimmer arrives, you will open the box to two metal bowls, this is the top and bottom half of the SpinPro Trimmer. The lower half contains the metal grill and trimming wires that are simple to fit in with the provided equipment. The top half contains the rubber fingers that help move the product around when moving the trimmer. The top also has a rubber seal around the rim just to stop any material coming out and to give the trimmer an airtight seal stopping any knocks or wobbles from opening the SpinPro while turning. The rotatable handle that will be in the box will then need to be attached. This is connected to the vertical spindle inside the top half of the SpinPro. Once attached this will control the trimming wire and move it around inside the bowl.
Once everything has been fitted and set up, you’re ready to go! Plant material can now be placed on the grill attached to the lower bowl. Once placed, the top half of the bowl should be fastened on top and the turning of the handle can commence. After a few turned all the sides of the material will get trimmed.
Fit the grill onto the top of the SpinPro bowl ensuring that it sits flat, and then put your plant material onto the grill. Don't try to trim too much at once. Roughly a litre at a time is about right. Smaller amounts are easier and quicker to trim than a large grill-full that has been piled up, and the trim quality will be better. Next place the SpinPro top bowl onto the top of the grill, making sure that it seats well over the rubber edge-seal.
Turn the handle at the rate of about one turn every 2 to 3 seconds. Don't turn it as fast as you can. The best trim will be gained from a medium trimming speed. The length of time it takes the SpinPro to finish trimming your plant material will vary depending on the type of plant and how much you put in to be trimmed. The clear top-bowl makes it easy to visually check how the trimming is progressing as you go. Generally speaking, a litre of plant material will be trimmed in under a minute.
Once your plant material has been trimmed thoroughly, take the top off the SpinPro and remove it. Place the next batch in if necessary. Every few batches, check under the grill and empty the trim out of the bottom bowl if necessary. Make sure that the SpinPro is cleaned well after use to maintain its effectiveness and lifespan.
The SpinPro Automatic Motor is a massive upgrade when using the SpinPro Original bowl trimmer. Made to fit the original, the Automatic motor is simply fitted onto the top of the bowl turning it into a self-rotating trimmer, so you don’t have to waste the time turning the spinner yourself! The Automatic motor is easy to assemble and attach onto the Original, coming with a couple of nuts and bolts that are simple to attach with the instruction manual that will be included with the automatic motor. The motor allows you to run the Spinpro at intervals of 1-99 seconds. The digital display timer is on top of the motor allowing you to change the amount of time you want it to turn to whatever you want.